US aviation shutdown blamed on single router

详细摘要

The problem that caused a nation-wide shutdown of the US aviation system and disrupted thousands of flights may have been the fault of a single router.

A massive, nearly five-hour shutdown of the US aviation system that disrupted more than 20,000 flights may have been the fault of a single router installed by government contractor L3Harris.

The incident is the latest painful example of the aging US air traffic control ‌telecom system and the struggles to replace systems while keeping the old communications working.

The Federal Aviation Authority's aging telecom systems in recent years have failed after errant fibre cuts, accidental deletion of files and ‌a strong chemical smell caused by a melted component. The system will fail again until it is properly upgraded, government officials said.

"This was an FAA system that didn't meet the moment," Transportation Secretary Sean Duffy said ‌on Saturday.

Duffy said on Friday L3Harris was conducting routine maintenance to switch telecommunication lines from old copper wire to fibre at at least one remote location. Officials told Reuters there may have been problems with routers installed in both Arkansas and Texas.

"We're working to determine whether we had incompetence, meaning was it user error or installer error from L3Harris, or did they install a faulty router? We haven't determined what the fault was," Duffy said.

L3Harris said it took the issue seriously and was "supporting the FAA in its investigation to understand the conditions that led to the Nov. 13 ground stop ‌of our nation’s air travel".

L3 ‌noted it has completed more ⁠than 70 per cent of the planned airspace communications conversion from legacy copper wires to a fibre-optic system.

The FAA spends $US1 billion ($A1.5 billion) annually to ​maintain its old copper wire system and is racing to replace it with more modern fibre-based communications.

文章开头，摘自AAP。如需阅读全文，请前往媒体网站。